Pypilot motor controllers by NaviTop
These motor controller needs to be paired with a suitable autopilot computer such as Tinypilot
or Openplotter running pypilot
News
Soon, pypilot-tinypilot hats for Pi Zero, including one with 433MHz remote receiver
New page about message "Bad_Fuses"
Pypilot motor controller12V 7A* by Navitop
*Motor current is the amount of amps drawn by the motor at maximum torque, allowing the rudder to move freely. It is not the current with the motor stalled. The peak current of this controller can be 15A.
This motor controller does not have a clutch control output.
PCB size : 76 x 57 x 25 mm
Prices without taxes and shipping
60€ : PCB marinized with tropicalizing acrylic varnish, without box, processor flashed with code, functions tested and waterproof 4 pins connection to pypilot computer
Available
20€
: box supplied with 4 screw Torx M3 -8
: box supplied with 4 screw Torx M3 -8
Available
5€ : Optional waterproof 3 pin connection to rudder feedback
Available
Available
Pypilot motor controller 12-24V 15A* with clutch output by NaviTop
*Motor current is the amount of amps drawn by the motor at maximum torque, allowing the rudder to move freely. It is not the current with the motor stalled. The peak current of this controller can be 25A.
The clutch output can supply 4A (max).
PCB size : 104 x 70 x 25 mm
Prices without taxes and shipping
105 € : PCB marinized with tropicalizing acrylic varnish, without box, processor flashed with code, functions tested and waterproof 4 pins connection to pypilot computer and waterproof 3 pin connection to rudder feedback
Available
25 € : box supplied with 5 screw Torx M3 -8
Available
5 € : Optional 90cm microUSB cable to allow reliable powering 5V DC for Pi Zero of the pypilot computer by motor controller 15A. Connection to controller via JST PH2 connector.
Available
5 € : Waterproof 3 pin connection to limit switches
Available
Available
5 € : Waterproof 4 pin connection to the limit switch proximity sensors to supply them with +5V
Available
Available
Pypilot motor controller 12-24V 30A* with clutch output by NaviTop
*Motor current is the amount of amps drawn by the motor at maximum torque, allowing the rudder to move freely. It is not the current with the motor stalled.
This motor controller is sized to supply 30A continuously in 12 or 24V.
The clutch output can supply 4A (max).
Box allowing easy fixing of cables using nylon collars.
PCB size : 107 x 117 x 43 mm
Prices without taxes and shipping
180 € : PCB marinized with tropicalizing acrylic varnish, without enclosure, flashed processor with code, tested functions, Wago 64A lever terminals for power input and motor, 32A for clutch and 1.5 mm² for UART to Pi and rudder feedback sensor. Supplied with a 4 pins waterproof UART connection.
Available
35 € : box supplied with 8 screw Torx M3 -8
Available
Available
5 € : Waterproof 4 pin connection to the limit switch proximity sensors with wire to supply them with +5V
Available
Available